Serving Chandler, Gilbert and Ahwatukee24/7 Emergency Dispatch: (480) 806-2944
☎ (480) 806-2944
24/7 Emergency Line Open
Gas line installation and repair • Sun Lakes, AZ

Gas Line Installation and Emergency Repair in Sun Lakes

If you smell gas, the first call is not to a plumber. Leave the house, phone 911 and the gas utility, and wait for clearance. A plumber handles the repair or new line after the immediate danger is dealt with.

  • Licensed and insured plumbers
  • Same-day service when available
  • 24/7 emergency dispatch
Gas water heater standing in a closet with a yellow flexible gas connector and a small white device on the floor
Gas leak safety

Smell Gas? Do These Things Before You Call a Plumber

Gas odor? Leave the house now. Do not turn lights or switches on or off, use a phone inside, or look for the source.

  1. Get everyone, including pets, outside and away from the house.
  2. Once outside, phone 911 and then the gas utility. Southwest Gas is listed as the gas utility for Sun Lakes.
  3. Stay out until the utility says it is safe.
  4. Call a plumber afterward to find and repair the cause, and ask about pressure testing before service is restored.

A plumber should not be the first call for a strong gas smell. A gas utility technician can shut off supply and check for leaks with the right equipment.

Source: Gas utility listed for Sun Lakes, Utilities for My Home

Gas line repair

Is the Gas Line Leaking or Just Old?

A gas line problem is not always dramatic. A faint smell near a connection, a hissing sound at a fitting or a flame that burns yellow can all point to a fault. A plumber checks the fittings with a pressure test or a leak solution and repairs the connection or the pipe.

Gas piping in older homes is usually black iron. It can corrode where it is damp or where it meets a fitting. Flexible connectors on appliances wear over time, and CSST, a flexible corrugated pipe, is used in some homes. Ask the plumber what you have and what condition it is in.

  • Smell near a range, dryer or water heater connection
  • Hissing sound near a gas fitting
  • A burner that burns yellow or orange instead of blue
  • Rust or corrosion on exposed gas pipe

A pressure test on a gas line is the way a plumber confirms the line holds. Ask for it after any repair or new connection.

Planned Gas Work? Describe the Job to Dispatch

Local • Plumbing • 24/7 dispatch

Tell dispatch which appliance or line is involved so a plumber can plan the visit.

☎ (480) 806-2944
Gas line installation

Gas Line Installation for Ranges, Dryers, Grills and Fireplaces

Adding a gas line means running pipe from an existing supply to a new appliance. Typical jobs are a range or cooktop, a dryer, an outdoor grill, a fireplace or a generator. Each one needs the right pipe size and a shutoff valve at the appliance.

Hand turning the gas control dial on a water heater, a yellow flexible gas line connected at left
Gas appliances connect through a flexible line and a shutoff like these. A new appliance added later needs its own supply point.

The community sits in unincorporated Maricopa County, where a new gas line needs a permit, according to the county, so ask who will pull it before work begins. Parts of the area border Chandler and Pinal County, which can have different rules, so confirm your jurisdiction.

Gas line installation basics
ApplianceWhat the plumber needs to knowCommon extras
Range or cooktopDistance from existing supply and the appliance ratingShutoff valve and flexible connector
DryerVenting and nearby gas stubConnector and shutoff
Grill or outdoor kitchenRun length and trench or wall routeQuick-connect fitting
Fireplace or generatorSize of supply and clearancesPressure test and permit

Source: Maricopa County Planning and Development, Permitting Services

Pipe replacement

Replacing Gas Pipe: Black Iron, CSST and Propane Lines

When a gas pipe is corroded or damaged, replacing it is safer than patching. Black iron is replaced with new threaded pipe, and CSST sections are replaced with matching fittings and proper bonding. The plumber also checks the supply pressure and the connections at each appliance.

Arm reaching to a copper line and a blue-handled valve above a water heater tank
Where supply piping meets an appliance, fittings and valves like these are looked over as part of replacing a line.

Homes that use propane have a tank and a regulator, which are handled by the propane supplier. A plumber covers the piping inside the house.

Not Sure What Type of Gas Pipe You Have?

Local • Plumbing • 24/7 dispatch

A plumber can identify it and explain what repair or replacement involves.

☎ (480) 806-2944
Before the work

Questions to Ask Before a Gas Line Job Begins

Gas work is not a place for guesses, so it helps to ask a few plain questions first. Who will pull the permit, and when will the inspection happen? What size and type of pipe will be used, and why? Will the line be pressure tested before the appliance is connected?

You should also ask what happens to the old line if one is being replaced, and whether the shutoff valve will sit where you can reach it. A clear answer to each of these tells you the plumber has planned the job rather than improvised it.

  • Who is responsible for the permit and inspection
  • What pipe material and size will be used
  • Where the shutoff valve will be placed
  • How the line will be pressure tested
  • Whether the appliance needs a new connector
After the work

After a Gas Repair: Pilot Lights, Appliances and Detectors

Once the line is repaired and tested, appliances are reconnected and checked for a steady blue flame. A utility technician may need to restore service if the supply was shut off at the meter, so allow time for that step.

Two hands holding a round metal cover with a barcode label while a finger points at the wires beneath
After a gas repair, the burner area and its wiring are worth a look before the appliance goes back in service.

A gas detector near the appliances adds a second warning if a fitting loosens later. Test the detector on the schedule its maker gives, and replace it at the end of its listed life. Keep the area around gas appliances clear of paper, cleaning supplies and anything that burns.

Quick answers

Gas Line Questions Answered

Do I call a plumber for a gas leak?

Not first. Leave the house, then call the emergency number and the utility from outside. A plumber repairs the line once the utility has made it safe.

Who can install a gas line for a stove?

Maricopa County states that a new gas line needs a permit in the unincorporated area where Sun Lakes sits. A licensed and insured plumber can install the line and tell you who handles the permit. Ask before work begins.

What should I do if I smell gas outside my house?
  1. Move away from the area and keep others away.
  2. Do not use switches, lighters or phones near the smell.
  3. From a safe distance, phone 911 and the utility.
  4. Do not return until the utility clears it.
What does gas line work cost?

Run length, pipe type, access and permits all shape the total, so the figure is left out. The cost factor guide lists what changes the price.

Related pages

Pages That Connect to Gas Work

A gas supply problem on a heater is covered on water heater repair, and new heaters on water heater installation. The home page lists first steps for any plumbing emergency.

Gas Work Planned? Call Dispatch

Local • Plumbing • 24/7 dispatch

For a smell of gas, leave and call 911 first. For repairs and new lines, call dispatch.

☎ (480) 806-2944
  • Licensed and insured plumbers
  • Same-day service when available
  • 24/7 emergency dispatch
Call now, 24/7